Is There A Fix For My Scan Snap Receipt Program Crashing

#	Software	Problem	Workaround
1	ScanSnap Dwelling house	This has been fixed past ScanSnap Abode ii.3.1 or later. "Failed to connect to the ScanSnap" may appear while ScanSnap is connected past USB and information technology becomes unable to connect past USB. ^(1) For models other than ScanSnap SV600 or ScanSnap S1300i* For ScanSnap SV600 and ScanSnap S1300i Notation: Even after closing this window by pressing OK push button, the error appears again when USB cable is unplugged and plugged in or ability off and on the ScanSnap.	Take either countermeasure to connect the ScanSnap again. Press the [Restore] button on the error message. Restart the computer. (while keeping the ScanSnap powered on and connected by USB) Restart the WIA service. ^(*2)
2	ScanSnap Managing director	This has been fixed by ScanSnap Director V7.2L21 or later. "Could not use the ScanSnap" may appear while ScanSnap is connected by USB and it becomes unable to connect by USB. ^(one) For models other than ScanSnap SV600 or ScanSnap S1300i* For ScanSnap SV600 and ScanSnap S1300i Note: Even after closing this window by pressing Shut push, the error appears again when USB cable is unplugged and plugged in or power off and on the ScanSnap.	This consequence does not occur with Wi-Fi connection. Accept the following countermeasure to connect the ScanSnap again. Restart the reckoner. (while keeping the ScanSnap powered on and continued past USB) Run [ScanSnap Support Tool] from the Start menu, click the [Recover] button in [Recover tab] to repair connexion. Restart the computer.
3	ScanSnap Manager	If ScanSnap SV600 and other ScanSnap scanners are connected to the computer with USB connexion and the computer resumes from slumber manner, the following fault bulletin may appear and information technology may non be able to connect to ScanSnap other than ScanSnap SV600. When scanning but with ScanSnap other than ScanSnap SV600 When scanning with ScanSnap SV600 and then scanning with any other ScanSnap	This problem does not occur when ScanSnap other than the ScanSnap SV 600 is connected with Wi-Fi connection. If this occurs, use one of the post-obit workarounds to connect to ScanSnap. Power off and on ScanSnap. Disconnect and reconnect the USB cablevision.

(*1)
This problem has been detected in the following cases.
- When a reckoner and a ScanSnap is connected past USB (and the scanner is turned on).
- After a estimator goes in hibernation (sleep) while connecting to ScanSnap and resumes from hibernation (slumber).
- When switching to connect another ScanSnap as follows.
  - -
    
    Connect two ScanSnap units past USB cable to a estimator, and switch a ScanSnap to connect from the [Select a scanner] listing in the scan window.
  - -
    
    Switch a ScanSnap to connect past disconnecting and connecting the USB cable from a ScanSnap to some other ScanSnap.
(*2)
Follow the steps below to restart the WIA service.
1. Search for "Services" from the Start menu to run it.
2. Correct-click Windows Prototype Conquering (WIA) and select Restart.
3. The post-obit screen appears. Restarting WIA is completed when the processing is completed.
4. Ensure that the status for Windows Image Acquisition (WIA) is Running.